By default, Vilfo uses a subnet of 192.168.0.1. If you need to change the subnet or the subnet mask Vilfo use, you can do so in one of two ways.

Changing subnet

Method 1 - During initial setup

  1. During the initial setup process, locate the text that says "If you need to change the subnet click here" at the bottom of the page and click the link click here.
  2. Enter the IP address into the field labeled Local IP address
  3. (Optional) Enter the subnet mask you want Vilfo to use by selecting an option from the drop-down labeled Subnet mask
  4. Click Update

Vilfo will apply the changes. Once Vilfo is available again you may need to restart your network devices.

Method 2 - From inside the the administrative interface

  1. Navigate to Settings -> Network in the Vilfo administrative interface
  2. Locate the section called Change Vilfo subnet
  3. Enter the IP-address into the field labeled Local IP address
  4. (Optional) Enter the subnet mask you want Vilfo to use by selecting an option from the drop-down labeled Subnet mask
  5. Check the box Yes, I know what I'm doing
  6. Click Update

Vilfo will apply the changes and perform a factory reset. Once Vilfo is available again you may need to restart your network devices. You will need to go through the initial setup process again as explained here.


Note! It is not recommended you change the the subnet mask value from the default 255.255.0.0.

Did this answer your question?